Include Page | ||||
---|---|---|---|---|
|
See Also
Petroleum Industry / Upstream / Subsurface E&P Disciplines / Fluid (PVT) Analysis
...
group | editors |
---|
...
bgColor | papayawhip |
---|
...
title | Editor |
---|
Excerpt | |
---|---|
Constant composition expansionA volume of undersaturated oil is expanded in a PV-cell in which all of the fluid is contained within the cell during a series of pressure decrements: usually from the initial pressure (or above) to the bubble point. (Fig. 3.2.2.). Differential vaporization experimentThe differential vaporization experiment defines the changing FVF and solution GOR below the bubble point pressure. Gas saturated oil is charged to a PV-cell and the pressure is reduced in steps below the bubble point; after each, the evolved gas is removed from the cell and its volume measured along with the volume of gas saturated oil remaining in the cell. Once the pressure has been reduced to atmospheric, the temperature is decreased from the reservoir value to 20 oС (60 oF), meaning that the final state is the stock tank condition (14.69 psi, 60 oF), at which the remaining oil in the cell is referred to as the "residual7' volume (stb), to which all oil volumes are related at any stage of depletion. (Fig. 3.2.3.). Separator testsThe series of separator tests is required to correct the results of the differential vaporization, which may be regarded as an absolute experiment, for the conditions of gas-oil surface separation applied in the field. Saturated oil is charged to a PV-cell at the bubble point and allowed to expand through separators (single, two, three stage, or more, each operating at different pressures and temperatures) to stock tank conditions (Fig. 3.2.4.). |
...
special | @self |
---|
Типы тестов
Пластовая нефть
- Исследование при постоянной массе CCE (PV-соотношение).
- Стандартная сепарация (Flash Vaporization).
- Ступенчатая сепарация (Separator test ).
- Дифференциальное разгазирование (Differential test).
Пластовый газ (газоконденсат)
- Исследование при постоянной массе CCE (PV-соотношение).
- Исследование при постоянном объёме на истощение (CVD).
- Стандартная сепарация (Flash Vaporization).
- Ступенчатая сепарация (Separator test).
Определяемые параметры
Определение физико-химических характеристик и свойств разгазированной нефти и газа сепарации
- плотность нефти после однократной (стандартной) и ступенчатой сепарации;
- плотность газа стандартной сепарации и каждой ступени сепарации;
- молекулярная масса нефти;
- вязкость кинематическая и динамическая при температурах 10, 20, 30, 40 50 0С;
- кислотное число;
- содержание в дегазированной (стабильной) нефти парафинов, смол, асфальтенов, воды, механических примесей, общей серы, хлористых солей;
- фракционный состав по Энглеру;
- температура застывания нефти;
- температура плавления парафина.
Определение физико-химических параметров пластового флюида
Для нефти:
- давление насыщения;
- газосодержание при однократной сепарации;
- объемный коэффициент нефти после однократной сепарации;
- вязкость при пластовых условиях;
- плотность при пластовых условиях;
- коэффициент сжимаемости пластовой нефти;
- компонентный состав нефти (до С9+) после однократной сепарации;
- компонентный состав газа однократной сепарации;
- плотность газа стандартной сепарации;
- компонентный состав пластовой нефти;
- объемный коэффициент пластовой нефти при ступенчатой сепарации;
- газосодержание при ступенчатой сепарации.
Для пластового газа:
- точка росы;
- конденсатогазовый фактор;
- плотность и вязкость пластового газа при пластовых условиях;
- компонентный состав конденсата (до С21+) после однократной сепарации;
- компонентный состав газа однократной сепарации;
- компонентный состав пластового газа;
- параметры дифференциальной конденсации пластового газа.
Ссылки
...